On the passenger side, it consists of a reverse mirror lens, a reverse mirror cover, a reverse mirror light (some models have side turn signals on the leaf panel), a reverse mirror bracket, and a motor, including all accessories of the reverse mirror, which can be directly installed)
1. First, break open a small gap with your hand, insert a long screwdriver, and pry open all the buckles; 2. Then you can see three screws, unplug the power interface, remove the three screws, and finally take them off; 3. It is best to keep the lenses. When disassembling the lenses, you need to put four fingers in with a circle of buckles around it. Put your fingers in the buckle position and apply a little force to mix them outward until you hear a clicking sound; 4. Then install the new rearview mirror assembly in the opposite direction of the photo
The basic structure of the Z4 suspension system comes from the BMW new 3 series, and some structural improvements have been made to make it more dynamic to operate than the previous suspension. The BMW Z4 is a focus coupe under the BMW brand, and its design is improved on the basis of the Z3. The long engine hood and very comfortable seats almost fall on the rear axle are very close to the back. The upward sloping tail of the new car is more attractive, coupled with clear concave and convex lines on both sides, Make the new car look more imposing than the Z3. These eye-catching lines are combined with first-class sports car performance: long wheelbase, short overhang, wide wheelbase, and a relatively low center of gravity
Copyright © 2021.Company name All rights reserved.