Front door interior panel introduce

The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)

Installation method of front door interior panel/rear door interior panel

1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back

BAIC Weiwang 307 introduce

The Weiwang 307 is an extended version of the Weiwang 306, with a length of 4495mm and a wheelbase of 2920mm. As a result, the Weiwang 307 has a larger rear space. The front face of the Weiwang 307 has a more overall feel, and the two mesh grilles make the vehicle more refined and upgraded to a certain extent. The red BAIC logo is also quite festive. It has an additional window on the side that can be opened, which can be used by rear passengers for ventilation and breathability, The interior environment of the Weiwang 307 will become better. Of course, the interior design of the Weiwang 307 is mainly practical, with a simple and simple console design that has obvious Japanese micro car characteristics. The speedometer is a traditional scale, and information such as the tachometer, water temperature gauge, oil gauge, and time are displayed through the digital instrument panel on the right. The Weiwang 307 can be equipped with four rows of seats, and the maximum number of passengers in the car can be increased to 9. If only two rows of seats are selected, So most car owners plan to use this car as a truck. After removing the rear seats, the rear compartment forms a complete loading space. In addition, there are many small storage spaces available on the Weiwang 307, which is very convenient. In terms of power, the Weiwang 307 currently only has a 1.2L four cylinder engine, with a maximum power of 63.5kW and a maximum torque of 108Nm. It is equipped with a 5-speed manual transmission and adopts rear wheel drive. The low-end models do not have steering assistance, making it difficult to turn the wheels in place