LUK introduce

The clutch three piece set refers to the clutch friction plate, clutch pressure plate, clutch release bearing. The clutch pressure plate is the most important component in the clutch assembly, which directly determines whether the clutch is installed trembling, heavy, and used for a long time. The quality of the clutch friction plate will determine the overall service life and shock absorption and noise reduction effect of the clutch. The clutch release bearing is an important part of the clutch release system, Its quality determines the separation efficiency of the clutch system and the wear rate of the pressure plate separation)

Installation method of clutch three piece set

This advocates installation in car repair shops, as the installation method for each car is different: 1. Clutch pressure plate: it is a crucial structure on the clutch, and its function plays a crucial role in driving safety of the car; 2. The clutch is located in the flywheel housing between the engine and transmission. The clutch assembly is screwed onto the rear plane of the flywheel, and the output shaft of the clutch is the input shaft of the transmission. During the driving process of the car, the driver can press or release the clutch pedal as needed, temporarily separating the engine and transmission and gradually engaging them to cut off or transmit power input from the engine to the transmission; 3. The clutch is a common component in mechanical transmission that can be disengaged or engaged in the transmission system at any time. The general requirement is smooth engagement, rapid and thorough separation; Easy to adjust and maintain, with small external dimensions; Small weight, good wear resistance, and sufficient heat dissipation capacity; Convenient and labor-saving, commonly used methods include clamp type and friction type

JAC iEVS4 introduce

The Jianghuai iEVS4 is an electrified upgrade based on the gasoline version of the Ruifeng S4. In terms of appearance, everyone should not be too unfamiliar with it. The overall appearance maintains the original design style of the Ruifeng S4, but makes some changes based on the characteristics of pure electric vehicles. The grille is no longer hollow, but adopts a fully enclosed design, with DC fast charging and AC slow charging interfaces below the middle cover plate. In terms of headlights, except for the lowest configuration model which uses halogen light sources, All other configurations use LED light source headlights and are equipped with lenses. The side dual cultivation creates a floating roof effect, with body dimensions of 4410/1800/1660mm in length, width, and height, and a wheelbase of 2620mm. The exterior rearview mirror only supports electric adjustment and does not support electric folding. In addition, the car does not have a 360 degree imaging function