Front hood (front hood) introduce

The deformation of the engine hood needs to be repaired through sheet metal. Go to a regular repair shop and the technician will help you handle it. If it is a serious impact deformation, it is recommended to replace it. Even after repairing the surface, the lower reinforcement plate will not be completely repaired, resulting in a significant decrease in the strength of the engine hood, which is not conducive to safe driving; Opening method: There is a cable under the steering wheel, and the handle is pulled open to unlock. Then, both hands lift the engine hood and it will be lifted to a certain height in the middle. Put your fingers in and there is a card that can be pushed in and pushed in to fully open the engine hood. If it is a hydraulic rod, simply pull the handle to open the engine hood)

The installation method of the engine hood in a car needs to be adjusted according to its position

When installing the engine hood on a car, it is necessary to adjust the position. If the installation position of the engine hood is not appropriate, adjustments can be made as follows: ① Unscrew the fixing bolts of the engine hood hinge, move the hinge up and down, left and right to adjust the engine hood. ② Rotate the engine hood buffer block to adjust the height of the engine hood so that it is flush with the front and side edges of the body. ③ After unscrewing the fixing bolts of the engine hood latch, move the latch up and down, left and right to adjust. ④ Close the engine hood and check for alignment with surrounding components, with even gaps

JAC iEVS4 introduce

The Jianghuai iEVS4 is an electrified upgrade based on the gasoline version of the Ruifeng S4. In terms of appearance, everyone should not be too unfamiliar with it. The overall appearance maintains the original design style of the Ruifeng S4, but makes some changes based on the characteristics of pure electric vehicles. The grille is no longer hollow, but adopts a fully enclosed design, with DC fast charging and AC slow charging interfaces below the middle cover plate. In terms of headlights, except for the lowest configuration model which uses halogen light sources, All other configurations use LED light source headlights and are equipped with lenses. The side dual cultivation creates a floating roof effect, with body dimensions of 4410/1800/1660mm in length, width, and height, and a wheelbase of 2620mm. The exterior rearview mirror only supports electric adjustment and does not support electric folding. In addition, the car does not have a 360 degree imaging function