fog lamp introduce

The following is an introduction to the functions of car front fog lights: 1. Let other vehicles see the car in foggy or rainy weather conditions where visibility is greatly affected by weather. 2. Install in the front of the car slightly lower than the headlights, used to illuminate the road when driving in rainy and foggy weather. 3. It can improve the visibility of the driver and surrounding traffic participants, To enable oncoming vehicles and pedestrians to detect each other from a distance, the following are the operation methods for activating the front and rear fog lights: 1. Joystick on type: Start the fog lights by rotating the switch on the joystick. When the button marked with the fog light signal is turned to the ON position, the front fog lights will turn on, and then turn the button down to the rear fog light position, that is, turn on the front and rear fog lights at the same time. 2. Button on type: Start the front and rear fog lights by pressing the button, and mark the fog light button near the dashboard or center console, Press the front and rear fog light buttons separately to turn on the front and rear fog lights)

Installation method of front fog lights/rear fog lights/LED fog lights/warning lights

1. First, remove the black outer shell of the vehicle fog light, pull out the wiring harness inside, remove the snake head, and leave the plug. 2. Remove the lining near the fog light inside the wheel hub, which can be pried open with a screwdriver or other tools for convenient installation of the fog light later. 3. Install the newly purchased fog light at the wiring harness plug that was just found, fix it with a screwdriver or other tools, and then install it at the dug circular hole, fix it, and finally restore the removed lining

JAC iEVS4 introduce

The Jianghuai iEVS4 is an electrified upgrade based on the gasoline version of the Ruifeng S4. In terms of appearance, everyone should not be too unfamiliar with it. The overall appearance maintains the original design style of the Ruifeng S4, but makes some changes based on the characteristics of pure electric vehicles. The grille is no longer hollow, but adopts a fully enclosed design, with DC fast charging and AC slow charging interfaces below the middle cover plate. In terms of headlights, except for the lowest configuration model which uses halogen light sources, All other configurations use LED light source headlights and are equipped with lenses. The side dual cultivation creates a floating roof effect, with body dimensions of 4410/1800/1660mm in length, width, and height, and a wheelbase of 2620mm. The exterior rearview mirror only supports electric adjustment and does not support electric folding. In addition, the car does not have a 360 degree imaging function