The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)
1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back
A few days ago, Mercedes Benz launched a new CLS260 model in the Chinese market, which was equipped with a 1.5T engine for nearly 600000 yuan, becoming a hot topic in the automotive industry. Recently, official images of the new car have also been exposed on the internet. In terms of design, the appearance of the CLS260 is basically consistent with the current higher-level model, continuing the low and smooth body lines of previous models. The waistline of the new car has been greatly simplified, It looks very simple. The contour lines at the rear are very clean, and the trapezoidal slanted tail light group uses LED light sources, with no other unnecessary designs. As an entry-level model of the CLS, the CLS 260 maintains a high degree of consistency in appearance design with other versions, equipped with full LED headlights as standard. 19 inch double five spoke wheels, and AMG exterior sports components will be optional
Copyright © 2021.Company name All rights reserved.