The deformation of the engine hood needs to be repaired through sheet metal. Go to a regular repair shop and the technician will help you handle it. If it is a serious impact deformation, it is recommended to replace it. Even after repairing the surface, the lower reinforcement plate will not be completely repaired, resulting in a significant decrease in the strength of the engine hood, which is not conducive to safe driving; Opening method: There is a cable under the steering wheel, and the handle is pulled open to unlock. Then, both hands lift the engine hood and it will be lifted to a certain height in the middle. Put your fingers in and there is a card that can be pushed in and pushed in to fully open the engine hood. If it is a hydraulic rod, simply pull the handle to open the engine hood)
When installing the engine hood on a car, it is necessary to adjust the position. If the installation position of the engine hood is not appropriate, adjustments can be made as follows: ① Unscrew the fixing bolts of the engine hood hinge, move the hinge up and down, left and right to adjust the engine hood. ② Rotate the engine hood buffer block to adjust the height of the engine hood so that it is flush with the front and side edges of the body. ③ After unscrewing the fixing bolts of the engine hood latch, move the latch up and down, left and right to adjust. ④ Close the engine hood and check for alignment with surrounding components, with even gaps
The B40, also known as the BAIC version of the Wrangler, has yet to be launched. Recently, domestic media has exposed spy photos of another off-road vehicle from BAIC, the B61, for the first time. It basically follows the concept car design that was unveiled at the auto show. In terms of power, the mass-produced car is expected to use a combination of a 2.4-liter engine and a 5-speed manual transmission
Copyright © 2021.Company name All rights reserved.