Front door interior panel introduce

The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)

Installation method of front door interior panel/rear door interior panel

1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back

Cheetah CS6 introduce

The Cheetah CS6 was launched in 2007 and is the first "main control all wheel drive SUV" in China The main control all wheel drive system has four switching modes, which can automatically switch between the four modes according to different road conditions within a speed of 100 kilometers per hour. It is a precedent for SUV style in China. The Cheetah CS6 is a city SUV with outstanding off-road performance and passing ability. The interior of the car is spacious and the power performance is excellent. The Cheetah CS6 is an SUV with outstanding off-road performance, with a total size of 4980mm in length and 1870mm in width, The GAC Changfeng Cheetah CS6 series models are equipped with three four cylinder engines, namely the 2.5-liter VM R425 diesel engine and the 2.4-liter Mitsubishi 4G64S4M.4G69 gasoline engine. The Cheetah CS6 model uses the 2.4-liter Mitsubishi 4G64S4M four cylinder gasoline engine, with a maximum power of 92kW/5250rpm and a maximum torque of 190Nm/2500-2750rpm