Front door interior panel introduce

The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)

Installation method of front door interior panel/rear door interior panel

1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back

Audi S7 introduce

The all-new Audi S7 sports model is synonymous with "excellent performance" and "dynamic design". It is equipped with Audi's new 4.0-liter V8 TFSI twin turbocharged fuel direct injection engine, with a power output of up to 309 kilowatts (420 horsepower). Due to the use of new "cylinder on-demand" technology, the average fuel consumption per 100 kilometers is only 9.6 liters and 9.7 liters, respectively. With advanced chassis, lightweight body, and exquisite interior, Make the all-new Audi the perfect masterpiece in the sports car market The S7 is developed based on the Audi A7, which is also the first generation model of this series The S7 Sportback and the regular Audi A7 Sportback, although not significantly different in appearance, have added some masculine muscle lines on the basis of their original luxury, showcasing a full sense of sportiness, including the addition of lower turbulence on the front bumper, honeycomb shaped left and right lower air intakes, and the addition of body side skirts. The rear bumper also adds lower turbulence, and the exhaust tailpipe is changed to a dual sided four out setting, At the same time, it comes standard with 19 inch aluminum alloy wheels, fully boasting the title of S7 Sportback in terms of performance