Front door interior panel introduce

The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)

Installation method of front door interior panel/rear door interior panel

1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back

Opel GT introduce

The all-new Opel GT sports car incorporates fashion elements into the design concept of a two seater sports car. It has a powerful front engine, rear wheel drive, a dynamic cab, and a specially designed fabric soft top. The slender front end, wide body, smooth exterior, and short suspension create its proud and unique figure The Opel GT, like the Sky, adopts an FR layout. The engine is a 260 horsepower 2.0-liter ECOTEC turbocharged version. The Opel GT accelerates from rest to 100 kilometers per hour in just 6 seconds, with a top speed of 230 kilometers per hour. The more obvious evidence of the Opel GT's American heritage is its origin. It will be produced at the General Motors factory in Wilmington, Delaware, just like the two American cars mentioned earlier The Opel GT sports car is a European sisters version of Pontic and a clone of Saturn Sky. It has two seats and is rear wheel drive. A 2.0-liter four cylinder ECOTEC turbocharged engine provides power, with a maximum horsepower of 260 hp. The car has a strong grip on the ground from 0 to 60 mph in less than 6 seconds. The 18 inch tires give the car an extremely strong grip. The Opel GT made its first global debut at the 76th Geneva International Auto Show in March 2006. It was launched in Europe in January 2007, starting at 30675 euros, about 308000 yuan