Front turn signal introduce

Turn signal is an important indicator light that is activated when a motor vehicle turns to remind the front, rear, left, right, and pedestrians to pay attention. The turn signal tube uses xenon gas tubes, a microcontroller control circuit, and the left and right rotate continuously to flash. The turn signal uses a flasher to achieve light flashing. It can be mainly divided into three types: wire blocking, capacitive, and electronic. Among them, wire blocking can be further divided into hot wire (electric heating) and wing type (bouncing), Electronic flashers can be divided into hybrid (with contact relays and electronic components) and fully electronic (without relays). For example, pop-up flashers use the principle of electric current thermal effect, which uses thermal expansion and contraction as power to cause sudden changes in the spring plate to connect and disconnect the contacts, achieving flashing lights. Turn signals are the most important device that represents the dynamic information of the car, installed in front and behind the body, and can be turned on when the car turns, providing safety assurance for driving, For your and others' safety, please use turn signals according to regulations, so that people can know the direction of the car in advance and make correct judgments)

Installation of front turn signals/rear turn signals/LED daytime running lights/side marker lights/front and rear position lights

Tool preparation: 1. First, we need to prepare the tools required for the entire process of installing car turn signals, including a screwdriver and a wire hook. Then, we need to prepare the car turn signals that need to be installed. 2. Turn on the double flash. As shown in the figure, open the car's key door, and press the switch button of the double flash by hand. This way, the car's double flash will open. Observe the position of the turn signal wire harness. Now we can take out the iron hook, You can make this iron hook yourself, just put it on a wire head. It's quite simple because we have a dual flash, so we can observe the position of the turn signal harness through the hole. 3. Hook out the turn signal. As shown in the figure, after we find the position of the turn signal harness, we use the small iron hook made to hook the harness, and then hook out the turn signal. Be careful to hook it slowly, Avoid disconnecting the wiring harness, and also be careful not to scratch the surface of the car, which may affect its appearance. For the first time installing a car turn signal, as shown in the figure, take out the car turn signal that needs to be installed. Let's take a closer look. There are two small snap holes on the turn signal lampshade that can be directly attached to the turn signal. Please find a good position and gently attach the turn signal to the lampshade. 4. Installation of the car turn signal. As shown in the figure, Gently clip the pre installed car turn signal light onto the card hole on the body of the car, making sure the position of the card is accurate. There is a small iron plate on one side of the turn signal light, so we need to install the plastic side first, and then gently fasten the side with the small iron plate!

Opel GT introduce

The all-new Opel GT sports car incorporates fashion elements into the design concept of a two seater sports car. It has a powerful front engine, rear wheel drive, a dynamic cab, and a specially designed fabric soft top. The slender front end, wide body, smooth exterior, and short suspension create its proud and unique figure The Opel GT, like the Sky, adopts an FR layout. The engine is a 260 horsepower 2.0-liter ECOTEC turbocharged version. The Opel GT accelerates from rest to 100 kilometers per hour in just 6 seconds, with a top speed of 230 kilometers per hour. The more obvious evidence of the Opel GT's American heritage is its origin. It will be produced at the General Motors factory in Wilmington, Delaware, just like the two American cars mentioned earlier The Opel GT sports car is a European sisters version of Pontic and a clone of Saturn Sky. It has two seats and is rear wheel drive. A 2.0-liter four cylinder ECOTEC turbocharged engine provides power, with a maximum horsepower of 260 hp. The car has a strong grip on the ground from 0 to 60 mph in less than 6 seconds. The 18 inch tires give the car an extremely strong grip. The Opel GT made its first global debut at the 76th Geneva International Auto Show in March 2006. It was launched in Europe in January 2007, starting at 30675 euros, about 308000 yuan