The steering gear assembly, also known as the steering gear, is the most important component of the steering system. Its function is to increase the force transmitted from the steering wheel to the steering transmission mechanism and change the direction of force transmission. The operation of the steering gear is fully hydraulic, which means there is no mechanical connection between the steering column and the steering wheel, and there is a hydraulic pipe or hose connection between the steering gear and the steering cylinder. When the steering wheel is turned, The steering gear delivers a relative amount of oil according to the rotation ratio of the steering wheel, which flows directly to the corresponding side of the control cylinder, while the oil on the other side returns to the fuel tank. The steering gear can be divided into gear rack and pinion steering gear, worm crank finger pin steering gear, circulating ball rack and pinion gear fan steering gear, circulating ball crank finger pin steering gear, worm roller steering gear, etc. according to the power assisted form, it can also be divided into mechanical (non assisted) steering gear, There are two types of power steering systems: pneumatic, hydraulic, electric, and electro-hydraulic)
Step 1: After we receive the steering wheel, how do we center it? Turn the steering wheel to the end of either side, which is to kill the steering wheel, make a number, circle it to the other side, and count how many circles there are. If it is 3 circles, the left and right sides will change to 1.5 circles, which is very easy to center. Step 2: Fix the steering wheel to the chassis installation position of the car and fix the screws, Based on the brake hubs on both sides (the one where the tire is installed), adjust the approximate position of the outer ball head of the steering wheel, screw the inner ball head into the outer ball head depth to the normal position, and keep the screw thread depth on both sides consistent. Fix the locking screw on the lower ball head under the brake disc. Step 3: Install the two tires on both sides, use a tape measure, and measure the distance between the front part of the two front wheels and the two rear tires on both sides to ensure consistency, Step 4: Determine the center position of the steering wheel, put on the cross joint, and tighten the screw. Step 5: Run a circle on the road to determine the position of the cross joint. If there is any deviation, make a simple adjustment until it is basically centered. If you are the owner of the car, make sure to ask the repair shop to adjust it in place. If the repairman finds it troublesome, you cannot find it troublesome, because the last step of four-wheel alignment can only do a simple adjustment of the front speed. Step 6:, Find a professional store with four-wheel positioning
The Beijing Mercedes-Benz GLK300 is equipped with Mercedes-Benz's 4Matic all-wheel-drive system, which means that all four wheels of the GLK will always have power transferred to the wheels from the engine via the transmission. This means that all four wheels of the GLK will always have power from the engine via the transmission and the splitter to the wheels. The GLK is not equipped with front or rear differential locks. The GLK is not equipped with front or rear differential locks. When one of the wheels slips, the 4Matic system uses the limited-slip function integrated into the ESP to lock one wheel by using the brakes to transfer power to the other wheel, thus realizing a function similar to differential lock.
Copyright © 2021.Company name All rights reserved.