The steering gear assembly, also known as the steering gear, is the most important component of the steering system. Its function is to increase the force transmitted from the steering wheel to the steering transmission mechanism and change the direction of force transmission. The operation of the steering gear is fully hydraulic, which means there is no mechanical connection between the steering column and the steering wheel, and there is a hydraulic pipe or hose connection between the steering gear and the steering cylinder. When the steering wheel is turned, The steering gear delivers a relative amount of oil according to the rotation ratio of the steering wheel, which flows directly to the corresponding side of the control cylinder, while the oil on the other side returns to the fuel tank. The steering gear can be divided into gear rack and pinion steering gear, worm crank finger pin steering gear, circulating ball rack and pinion gear fan steering gear, circulating ball crank finger pin steering gear, worm roller steering gear, etc. according to the power assisted form, it can also be divided into mechanical (non assisted) steering gear, There are two types of power steering systems: pneumatic, hydraulic, electric, and electro-hydraulic)
Step 1: After we receive the steering wheel, how do we center it? Turn the steering wheel to the end of either side, which is to kill the steering wheel, make a number, circle it to the other side, and count how many circles there are. If it is 3 circles, the left and right sides will change to 1.5 circles, which is very easy to center. Step 2: Fix the steering wheel to the chassis installation position of the car and fix the screws, Based on the brake hubs on both sides (the one where the tire is installed), adjust the approximate position of the outer ball head of the steering wheel, screw the inner ball head into the outer ball head depth to the normal position, and keep the screw thread depth on both sides consistent. Fix the locking screw on the lower ball head under the brake disc. Step 3: Install the two tires on both sides, use a tape measure, and measure the distance between the front part of the two front wheels and the two rear tires on both sides to ensure consistency, Step 4: Determine the center position of the steering wheel, put on the cross joint, and tighten the screw. Step 5: Run a circle on the road to determine the position of the cross joint. If there is any deviation, make a simple adjustment until it is basically centered. If you are the owner of the car, make sure to ask the repair shop to adjust it in place. If the repairman finds it troublesome, you cannot find it troublesome, because the last step of four-wheel alignment can only do a simple adjustment of the front speed. Step 6:, Find a professional store with four-wheel positioning
The Kia K3 PHEV has been launched at the Chengdu Auto Show, with two models priced at 166800 yuan and 175800 yuan respectively after subsidies. As a pure electric plug-in hybrid model with a range of up to 80 kilometers, the arrival of the Kia K3 PHEV not only expands Kia's new energy product line, but also brings considerable pressure to several competitors. As one of the few compact plug-in hybrid products in the domestic market, the Kia K3 PHEV is a joint venture, The car is not only equipped with a power battery pack with a capacity of 12.9kWh, which enables its pure electric range to reach 80km, but also is equipped with a Kappa 1.6 GDi engine with a thermal efficiency of up to 40%, which is integrated with a long endurance electric drive system, resulting in a comprehensive fuel consumption of as low as 1L/100km. This also means that when the K3 PHEV is in a full fuel and full charge state, the car's range can reach 1080 kilometers
Copyright © 2021.Company name All rights reserved.