steering assembly introduce

The steering gear assembly, also known as the steering gear, is the most important component of the steering system. Its function is to increase the force transmitted from the steering wheel to the steering transmission mechanism and change the direction of force transmission. The operation of the steering gear is fully hydraulic, which means there is no mechanical connection between the steering column and the steering wheel, and there is a hydraulic pipe or hose connection between the steering gear and the steering cylinder. When the steering wheel is turned, The steering gear delivers a relative amount of oil according to the rotation ratio of the steering wheel, which flows directly to the corresponding side of the control cylinder, while the oil on the other side returns to the fuel tank. The steering gear can be divided into gear rack and pinion steering gear, worm crank finger pin steering gear, circulating ball rack and pinion gear fan steering gear, circulating ball crank finger pin steering gear, worm roller steering gear, etc. according to the power assisted form, it can also be divided into mechanical (non assisted) steering gear, There are two types of power steering systems: pneumatic, hydraulic, electric, and electro-hydraulic)

Installation steps for steering gear assembly/steering gear assembly

Step 1: After we receive the steering wheel, how do we center it? Turn the steering wheel to the end of either side, which is to kill the steering wheel, make a number, circle it to the other side, and count how many circles there are. If it is 3 circles, the left and right sides will change to 1.5 circles, which is very easy to center. Step 2: Fix the steering wheel to the chassis installation position of the car and fix the screws, Based on the brake hubs on both sides (the one where the tire is installed), adjust the approximate position of the outer ball head of the steering wheel, screw the inner ball head into the outer ball head depth to the normal position, and keep the screw thread depth on both sides consistent. Fix the locking screw on the lower ball head under the brake disc. Step 3: Install the two tires on both sides, use a tape measure, and measure the distance between the front part of the two front wheels and the two rear tires on both sides to ensure consistency, Step 4: Determine the center position of the steering wheel, put on the cross joint, and tighten the screw. Step 5: Run a circle on the road to determine the position of the cross joint. If there is any deviation, make a simple adjustment until it is basically centered. If you are the owner of the car, make sure to ask the repair shop to adjust it in place. If the repairman finds it troublesome, you cannot find it troublesome, because the last step of four-wheel alignment can only do a simple adjustment of the front speed. Step 6:, Find a professional store with four-wheel positioning

BYD introduce

The BYD Subaru is a new model launched by BYD after its brand strategic transformation. The biggest highlight of this car is its remote control driving technology, which allows drivers to control the vehicle within a visible range of 20 meters around the vehicle through the remote control key. The Subaru's remote control driving technology won the Best Leading Technology Award at the 2012 Beijing Auto Show. Equipped with a 1.5T turbocharged engine, the BYD Subaru has a maximum power of 154 horsepower, The acceleration from 100 kilometers per hour of this car is 8.9 seconds. As a premium model of BYD, BYD has invested more in the Sagitar and advanced towards a higher level of design philosophy. The interior of the car is relatively fashionable, atmospheric, and the exterior has perfect lines, ensuring safety, quality, and reliability