Front door interior panel introduce

The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)

Installation method of front door interior panel/rear door interior panel

1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back

Isuzu D-MAX introduce

The domestically produced Isuzu D-MAX pickup truck was officially launched on December 7th. The new car will be equipped with a 2.5T diesel engine and offer optional four-wheel drive models. A total of six models have been launched. The length, width, and height of the domestically produced Isuzu D-MAX are 5295mm/1860mm/1795mm, respectively, and the wheelbase has been extended to 3095mm, which is quite impressive. The double row seat design is very suitable for domestic users, and the standard 5-seat design can meet daily use needs. The domestically produced Isuzu D-MAX adopts a 5-seat design, The high-end models are also equipped with leather seats and electric adjustment functions, and the comfort configuration is not poor. The biggest highlight is still the rear seats, and legroom is usually the soft rib of a pickup truck. However, the D-MAX's rear seats are very spacious, and the backrest angle also has a certain tilt. The Isuzu D-MAX offers two body height models, and the four-wheel drive version has a minimum ground clearance of 205mm. In terms of power, the overseas version of the D-MAX has two versions of diesel engines, 2.5T and 3.0T, But the domestically introduced D-MAX will only be equipped with one 2.5T diesel engine, with a maximum power of 100kW (136PS) and a maximum torque of 320Nm