tail lamp introduce

Front and rear position lights, commonly known as small lights or width indicator lights, are mainly used to indicate the presence and overall width of a car, making it easier for other vehicles to judge when passing or overtaking. Brake signal lights, commonly known as brake lights, are warning lights used to remind vehicles behind that the car has taken braking measures. They are installed at the rear of the car, red, and when the car brakes, the line is connected, Automatically emitting red light. Due to the significant importance of brake lights to car safety, their brightness is significantly higher than that of rear position lights, generally more than five times the brightness of rear position lights. It can be seen clearly from a distance of more than 100m during the day. Non standard terminology: brake lights)

Installation of rear tail lights, fog lights, and brake lights

1. Open the trunk and use a Phillips screwdriver or socket to remove the bolts. Pull the lamp assembly out of the rear pillar. 2. Rotate the socket counterclockwise and remove it, remove the old bulb, and insert the new bulb. 3. Slide the lamp assembly into the guide groove on the body. 4. Align the pins with the body washers, and then push them in until they fully fit

Mercedes-Benz GLC300L introduce

1. Mercedes Benz GLC300L handling and sound insulation. In this regard, since I have not driven any other car before, I don't have much say. Compared to previous small cars, that is much better. After all, the money has also increased a lot (other test drives are like blind dates, so short time and distance, many cannot be seen or tested). 2. Mercedes Benz GLC300L full-time four-wheel drive, compared to the original front wheel drive small car, I don't feel any difference. 3. The seats of Mercedes Benz GLC300L are really soft and comfortable, And there is also leg rest and lumbar support, which is very comfortable. 4. The Mercedes Benz GLC300L has a good seat memory, so there is no need to switch it with my wife. It can be adjusted back and forth, but why do I need to press and hold the adjustment button for a long time? Is it not good to make it only press once and it will be okay