The following is an introduction to the functions of car front fog lights: 1. Let other vehicles see the car in foggy or rainy weather conditions where visibility is greatly affected by weather. 2. Install in the front of the car slightly lower than the headlights, used to illuminate the road when driving in rainy and foggy weather. 3. It can improve the visibility of the driver and surrounding traffic participants, To enable oncoming vehicles and pedestrians to detect each other from a distance, the following are the operation methods for activating the front and rear fog lights: 1. Joystick on type: Start the fog lights by rotating the switch on the joystick. When the button marked with the fog light signal is turned to the ON position, the front fog lights will turn on, and then turn the button down to the rear fog light position, that is, turn on the front and rear fog lights at the same time. 2. Button on type: Start the front and rear fog lights by pressing the button, and mark the fog light button near the dashboard or center console, Press the front and rear fog light buttons separately to turn on the front and rear fog lights)
1. First, remove the black outer shell of the vehicle fog light, pull out the wiring harness inside, remove the snake head, and leave the plug. 2. Remove the lining near the fog light inside the wheel hub, which can be pried open with a screwdriver or other tools for convenient installation of the fog light later. 3. Install the newly purchased fog light at the wiring harness plug that was just found, fix it with a screwdriver or other tools, and then install it at the dug circular hole, fix it, and finally restore the removed lining
The Dongfeng Xiaokang K07 II is a van under the Dongfeng brand. It has been adjusted at the front grille, and the layered lines on the side of the body are more prominent. Compared with the old model, the exterior design of the Dongfeng Xiaokang K07 II has been slightly modified. The front grille has been adjusted, and the layered lines on the side of the body are more prominent. In terms of size, its length has increased by 80mm, The height has been reduced by 40mm. This time, we are introducing the lowest configuration model of the entire series - the 1.0L practical model. The front and rear bumpers of the car are black, priced at 29800 yuan. In terms of space, when a 176cm tall tester sits in the car, the front headroom is two fists, and the rear legroom is also two fists. The headroom is more than two fists, and the slight headroom has never been a problem. In terms of the trunk, its minimum depth is 1110mm, Folding the rear seats can expand to 1940mm, but folding them requires the use of tools, which is somewhat inconvenient. Due to the limited size of the body, the performance of the trunk can only be described as average compared to the other three models
Copyright © 2021.Company name All rights reserved.