• Website for purchasing dismantled parts
  • 8:00-18:00
Dongfeng Xiaokang K07 II Throttle assembly

Dongfeng Xiaokang K07 II Throttle assembly

  • Price:please consult customer service
  • Transportation costs:Negotiate with sales personnel

number:

Throttle assembly introduce

The function of the throttle valve assembly is as follows: 1. The throttle valve of a car is a controllable valve used to control the air entering the engine. After entering the intake pipe, it mixes with gasoline (different vehicles have different mixing parts) to become a combustible mixture gas, participating in combustion and doing work. It is one of the steps to provide power for the vehicle; 2. The throttle valve is the most important component of today's electronic fuel injection vehicle engine system. Its upper part is the air filter, and the lower part is the engine block, which is the throat of the car engine and controls the vehicle's travel speed; 3. The agility of a car's acceleration is closely related to the cleanliness of the throttle valve. The owner controls the throttle valve opening by stepping on the acceleration valve to achieve the goal of slowing down)

Installation position of throttle body

The throttle body is installed at the intake manifold of the engine. The throttle body mainly includes two types: traditional cable type and electronic throttle. The traditional engine throttle control mechanism works by connecting one end to the accelerator pedal and the other end to the throttle linkage plate through a cable (soft steel wire) or rod. The electronic throttle is mainly controlled by the throttle position sensor to control the opening angle of the throttle according to the required energy of the engine, So as to adjust the size of the intake volume. The throttle valve is installed in front of the manifold and behind the hose. The throttle valve is a controllable valve that controls the air to enter the engine. After the gas enters the intake pipe, it will mix with gasoline to form a combustible mixture, which burns and does work. The phenomenon of a broken throttle valve is: 1. The engine idle is unstable, and the high idle does not decrease continuously; 2. Difficulty in starting the engine; 3. Insufficient engine power, poor acceleration performance, and unstable operation; 4. The exhaust pipe of the car emits black smoke; 5. The engine malfunction light is on. The method to clean the throttle valve is: 1. Turn off the ignition switch and remove the negative pole of the battery; 2. Remove the throttle cable, intake hose, and screws securing the throttle valve in sequence; 3. Use cleaning agent to clean the throttle valve, and wipe any areas that cannot be cleaned with cotton thread

Dongfeng Xiaokang K07 II introduce

The Dongfeng Xiaokang K07 II is a van under the Dongfeng brand. It has been adjusted at the front grille, and the layered lines on the side of the body are more prominent. Compared with the old model, the exterior design of the Dongfeng Xiaokang K07 II has been slightly modified. The front grille has been adjusted, and the layered lines on the side of the body are more prominent. In terms of size, its length has increased by 80mm, The height has been reduced by 40mm. This time, we are introducing the lowest configuration model of the entire series - the 1.0L practical model. The front and rear bumpers of the car are black, priced at 29800 yuan. In terms of space, when a 176cm tall tester sits in the car, the front headroom is two fists, and the rear legroom is also two fists. The headroom is more than two fists, and the slight headroom has never been a problem. In terms of the trunk, its minimum depth is 1110mm, Folding the rear seats can expand to 1940mm, but folding them requires the use of tools, which is somewhat inconvenient. Due to the limited size of the body, the performance of the trunk can only be described as average compared to the other three models

Customer Reviews

  • 1.We will vary based on your shipping address and the chosen delivery method, and the general delivery time is 1-7 days
  • 2.All products sold and shipped from our company are genuine commercial accessories
  • 3.Each order comes with a Chinese printed "outbound list", which can be used as a unit accounting voucher and will be shipped together with the package
  • 4.If replacement is required, please keep the accessories clean and intact in packaging, along with the delivery note, and send them back. Our company promises to guarantee return and exchange within 15 days
  • 5.Special note: ordering accessories from the manufacturer is not covered by the warranty

Other Parts