Shift mechanism assembly introduce

The shifting structure of automobiles is divided into gear lever, cable, gear selection and shifting structure, shift fork and synchronizer. The function of the gear lever is to control the gear position, engage and disengage gears. The function of the cable is to pull the gear position and provide gear changes. The function of the gear selection and shifting structure is to distinguish between engaging gears or gear changes. The function of the shift fork and synchronizer is to combine and separate the gears of each gear position)

Installation of gear shifting mechanism assembly

(1) Remove the battery ground wire and odometer flexible shaft (2). Remove the clutch cable from the clutch release fork drive arm (3) Remove the connecting bolts (4) between the upper part of the shifting mechanism assembly housing and the engine. Remove the middle bracket of the engine, remove the engine exhaust device (5), and remove the transmission shaft from the shifting mechanism assembly. (6) Remove the reverse light and fuel consumption indicator wiring harness connectors. Remove the front lower protective plate of the shifting mechanism assembly housing and remove the starter (7) Loosen the fixing screws between the shift lever connector and the inner gear lever. Press out the support rod from the ball head of the shift lever connector to separate the inner gear lever from the shift lever connector. Install the 2071 support plate on the xx jack and gently lift the transmission

Dongfeng Xiaokang K07 II introduce

The Dongfeng Xiaokang K07 II is a van under the Dongfeng brand. It has been adjusted at the front grille, and the layered lines on the side of the body are more prominent. Compared with the old model, the exterior design of the Dongfeng Xiaokang K07 II has been slightly modified. The front grille has been adjusted, and the layered lines on the side of the body are more prominent. In terms of size, its length has increased by 80mm, The height has been reduced by 40mm. This time, we are introducing the lowest configuration model of the entire series - the 1.0L practical model. The front and rear bumpers of the car are black, priced at 29800 yuan. In terms of space, when a 176cm tall tester sits in the car, the front headroom is two fists, and the rear legroom is also two fists. The headroom is more than two fists, and the slight headroom has never been a problem. In terms of the trunk, its minimum depth is 1110mm, Folding the rear seats can expand to 1940mm, but folding them requires the use of tools, which is somewhat inconvenient. Due to the limited size of the body, the performance of the trunk can only be described as average compared to the other three models