Front door interior panel introduce

The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)

Installation method of front door interior panel/rear door interior panel

1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back

PUMPING IRON introduce

The large curved body surface, headlights, turn signals, and scattered front grille, as well as the huge wheel arches and hidden spare tire rack that affect the rear view, all inject new inspiration into the calm and stable SUV design The VehiCROSS series is equipped with a 3.5-liter 24 valve V6 engine, which is the most powerful engine equipped by Isuzu in SUVs, with a maximum power of 160kW and a maximum torque of 312Nm The VX-4 is equipped with an all aluminum engine and a 4-speed automatic transmission, and uses the "Instant Torque (TOD)" automatic full-time four-wheel drive technology, which can obtain the required power according to climate and road conditions. Under normal driving conditions, the TOD system behaves as rear wheel drive, but when the road conditions change, it will transmit torque to the front wheels as needed to provide sufficient grip TOD uses 12 sensors to detect the working status of each half axle, including vehicle speed, axle speed, throttle opening, braking, and ABS system status, to prevent tire adhesion loss