Front door interior panel introduce

The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)

Installation method of front door interior panel/rear door interior panel

1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back

BAIC 212 introduce

BAIC 212 Series: Founded in 1958, Beijing Automotive Manufacturing Co., Ltd. is a representative of BAIC's independent brand. For more than 40 years, BAIC has focused on the development and production of light off-road vehicles and trucks, and has won the reputation of "off-road family". The BAIC BJ-212 was first developed in 1964, and in 1965, the BJ-212 series off-road vehicles were officially finalized. The BJ-212 at that time adopted a detachable soft top design, The BJ-212 Jeep is mainly used for commander riding, weapon transportation, and other purposes. It adopts front and rear steel plate spring non independent suspension, which has strong off-road capabilities. It finally achieved mass production in 1966. In terms of body size, its length, width, and height are 3910mm, 1760mm, and 1880mm respectively, with a wheelbase of 2310mm. In terms of power, the BJ-212 Jeep is equipped with a 2445cc inline four cylinder gasoline engine, which adopts four-wheel drive and front and rear drum brakes, Matched with the engine is a 3-speed manual transmission, which has a maximum power of 75 horsepower, a maximum torque of 172 Nm, a weight of 1395kg, a maximum speed of 120-130 km/h, and a fuel consumption of approximately 14L per 100 kilometers