Front door interior panel introduce

The part names of the interior panel of the left front door, from top to bottom, are: left front door glass, left front mirror, left front glass sealing strip, those with decorative strips on the outside are called left front door decorative strip. The left front door is decomposed into left front door, mirror, glass, door lock, door glass controller, door glass elevator, mirror controller, left front door interior panel, handle, etc. The car is structurally divided into frame, outer panel, chassis, engine, interior, glass, tire, and is functionally divided into electrical system and driving system Driving system, oil and gas system, filtration system, control system, cooling system)

Installation method of front door interior panel/rear door interior panel

1、 Prepare tools and work vehicles or workbenches. 2. Open the car door to its maximum size for easier operation of the hinge support. Place a bracket at the lower edge of the car door to support the weight of the door and protect it. Unscrew the window glass. In this example, the disassembly of the car door will be mainly introduced. If the car door needs to be disassembled before disassembly, the outdoor rearview mirror should be removed. 3. Disconnect the wire connector between the car door and the vehicle body to separate the door wiring harness, If necessary, first remove the inner decorative parts on the pillar. 4. Remove the clamp at the bottom of the door stopper locking pin and extract the locking pin from the hole. 5. Hold the door and remove the connecting bolt of the door hinge support. After removing the door, place it vertically on a padded surface. If only the door needs to be removed for maintenance, it is recommended to complete the disassembly of the door by removing the hinge connecting bolt instead of the fixed bolt, This can reduce the adjustment work of the car door. 6. Check the sleeve of the car door chain, replace it if necessary, lubricate the hinge joint, place the car door back on the hinge support, and reinstall the bolts. 7. Connect the door limiter, install the stop lock pin and locking plate, and connect the electrical plug. 8. Close the car door, check if it is aligned, and if there is no problem, tighten the hinge fixing bolts. 9. Note that if the front door is disassembled and assembled, it is necessary to install the rearview mirror back

Toyota Yaris L introduce

The Toyota Yaris L, with a body length of 4115mm and a wheelbase of 2550, gives it a significant advantage in space and other aspects compared to competing models such as Honda Fit, Volkswagen Polo, and Ford Fiesta. This car has two powertrain options and six configuration models are available in China, The guide price ranges from 69800 to 108800 yuan. The Zhixuan does not have many configurations specifically designed to improve comfort. The seat positions of all models are manually adjusted. This sporty version of the model uses fabric seats, which are very sporty and wrap around the body well. However, the seat softness is not high, and sitting for a long time may be uncomfortable. In idle mode, the Zhixuan appears very quiet, but when the speed reaches a certain value, the noise becomes very obvious, At speeds of 60km/h and 80km/h, the noise levels are 59.8 and 62.3 decibels, respectively. At this time, most of the noise comes from the engine and wind noise, and there is no sense of the noise caused by resonance of certain components inside the car