The deformation of the engine hood needs to be repaired through sheet metal. Go to a regular repair shop and the technician will help you handle it. If it is a serious impact deformation, it is recommended to replace it. Even after repairing the surface, the lower reinforcement plate will not be completely repaired, resulting in a significant decrease in the strength of the engine hood, which is not conducive to safe driving; Opening method: There is a cable under the steering wheel, and the handle is pulled open to unlock. Then, both hands lift the engine hood and it will be lifted to a certain height in the middle. Put your fingers in and there is a card that can be pushed in and pushed in to fully open the engine hood. If it is a hydraulic rod, simply pull the handle to open the engine hood)
When installing the engine hood on a car, it is necessary to adjust the position. If the installation position of the engine hood is not appropriate, adjustments can be made as follows: ① Unscrew the fixing bolts of the engine hood hinge, move the hinge up and down, left and right to adjust the engine hood. ② Rotate the engine hood buffer block to adjust the height of the engine hood so that it is flush with the front and side edges of the body. ③ After unscrewing the fixing bolts of the engine hood latch, move the latch up and down, left and right to adjust. ④ Close the engine hood and check for alignment with surrounding components, with even gaps
In terms of appearance, although this car is a pure electric box truck, its appearance tends to be designed in the style of a concept car. Because it does not need to collide with the wind and dissipate heat like an oil burning motor vehicle, the front face of the car only uses a banner style black paint decorative panel, which is integrated with daytime running lights, making the entire truck look full of texture. Although the rear end is relatively square, the rich line design gives the rear end a certain sense of hierarchy, The rectangular tail lights with a vertical bar style are also very stylish, and the lighting effect is stunning. According to the vehicle positioning, the Weiwang 407EV can not only enter through the rear door in crowded streets, but also through the sliding door on the right side. The tail door adopts a 4/6 ratio split design, making it more convenient and flexible to get off and transport goods. The entire trunk volume of the car is 4.5 cubic meters, and the load capacity can reach 810kg
Copyright © 2021.Company name All rights reserved.