The following is an introduction to the functions of car front fog lights: 1. Let other vehicles see the car in foggy or rainy weather conditions where visibility is greatly affected by weather. 2. Install in the front of the car slightly lower than the headlights, used to illuminate the road when driving in rainy and foggy weather. 3. It can improve the visibility of the driver and surrounding traffic participants, To enable oncoming vehicles and pedestrians to detect each other from a distance, the following are the operation methods for activating the front and rear fog lights: 1. Joystick on type: Start the fog lights by rotating the switch on the joystick. When the button marked with the fog light signal is turned to the ON position, the front fog lights will turn on, and then turn the button down to the rear fog light position, that is, turn on the front and rear fog lights at the same time. 2. Button on type: Start the front and rear fog lights by pressing the button, and mark the fog light button near the dashboard or center console, Press the front and rear fog light buttons separately to turn on the front and rear fog lights)
1. First, remove the black outer shell of the vehicle fog light, pull out the wiring harness inside, remove the snake head, and leave the plug. 2. Remove the lining near the fog light inside the wheel hub, which can be pried open with a screwdriver or other tools for convenient installation of the fog light later. 3. Install the newly purchased fog light at the wiring harness plug that was just found, fix it with a screwdriver or other tools, and then install it at the dug circular hole, fix it, and finally restore the removed lining
In terms of appearance, although this car is a pure electric box truck, its appearance tends to be designed in the style of a concept car. Because it does not need to collide with the wind and dissipate heat like an oil burning motor vehicle, the front face of the car only uses a banner style black paint decorative panel, which is integrated with daytime running lights, making the entire truck look full of texture. Although the rear end is relatively square, the rich line design gives the rear end a certain sense of hierarchy, The rectangular tail lights with a vertical bar style are also very stylish, and the lighting effect is stunning. According to the vehicle positioning, the Weiwang 407EV can not only enter through the rear door in crowded streets, but also through the sliding door on the right side. The tail door adopts a 4/6 ratio split design, making it more convenient and flexible to get off and transport goods. The entire trunk volume of the car is 4.5 cubic meters, and the load capacity can reach 810kg
Copyright © 2021.Company name All rights reserved.