Reverse mirror assembly introduce

On the passenger side, it consists of a reverse mirror lens, a reverse mirror cover, a reverse mirror light (some models have side turn signals on the leaf panel), a reverse mirror bracket, and a motor, including all accessories of the reverse mirror, which can be directly installed)

Installation method of reverse mirror assembly/rearview mirror assembly

1. First, break open a small gap with your hand, insert a long screwdriver, and pry open all the buckles; 2. Then you can see three screws, unplug the power interface, remove the three screws, and finally take them off; 3. It is best to keep the lenses. When disassembling the lenses, you need to put four fingers in with a circle of buckles around it. Put your fingers in the buckle position and apply a little force to mix them outward until you hear a clicking sound; 4. Then install the new rearview mirror assembly in the opposite direction of the photo

Jaguar XFL introduce

The Jaguar XFL was launched in 2016. In terms of exterior design, the domestically produced Jaguar XFL is basically the same as the imported version, with only a significant increase in body length, but the extended wheelbase does not damage the original side profile. In terms of size, the length, width, and height of the Jaguar XFL are 5093/1880/1456mm respectively, with a wheelbase of 3100mm, an increase of 140mm compared to the imported Jaguar XFL. In terms of space, the rear knee space of the domestically produced XFL has increased by 116mm, reaching 203mm, Legroom increased by 157 mm. In terms of power, the Jaguar XFL will be equipped with a 2.0T engine, available in 200Ps and 240Ps high and low power versions, with a 0-100 km/h time of 8.1 seconds and 7.4 seconds respectively. In addition, the new car will also offer a 3.0T V6 turbocharged engine version, with a maximum power of 340 Ps and a 0-100 km/h time of 6.0 seconds