electron fan introduce

The working principle and function of a car electronic fan are: 1. The working principle is that the car electronic fan is controlled by a temperature controller. When the water temperature rises to the upper limit, the temperature controller connects the power supply, and the fan starts to work. When the water temperature drops to the lower limit, the temperature controller turns off the power supply, and the fan stops working; 2. Its function is to cool the engine block and gearbox, and provide heat dissipation for the air conditioning condenser. The method of replacing the electronic fan is: 1. Open the engine hood of the car and remove the intake pipe located above the fan; 2. Use professional tools to unscrew screws; 3. Unscrew all screws and remove the fan from the car; 4. Install the new fan correctly on the new fan bracket and tighten the four fixing screws; 5. Start the engine to test whether the fan can operate normally. After checking for accuracy, install the intake pipe in the correct position. The Helper Auto Parts Platform provides ordering services for original electronic fan parts for various vehicle models)

The installation method for the electronic fan inside a car is as follows:

The installation method for the electronic fan in the car is as follows: 1. First, remove the intake module from the engine compartment, and then unplug the water tank fan cable hidden behind the intake module; 2. Then lift the car and loosen the fixing screws of the water tank from under the engine to allow the water tank to sink; 3. Remove the radiator fan module from the bottom of the car and replace it with a new fan

Jaguar XFL introduce

The Jaguar XFL was launched in 2016. In terms of exterior design, the domestically produced Jaguar XFL is basically the same as the imported version, with only a significant increase in body length, but the extended wheelbase does not damage the original side profile. In terms of size, the length, width, and height of the Jaguar XFL are 5093/1880/1456mm respectively, with a wheelbase of 3100mm, an increase of 140mm compared to the imported Jaguar XFL. In terms of space, the rear knee space of the domestically produced XFL has increased by 116mm, reaching 203mm, Legroom increased by 157 mm. In terms of power, the Jaguar XFL will be equipped with a 2.0T engine, available in 200Ps and 240Ps high and low power versions, with a 0-100 km/h time of 8.1 seconds and 7.4 seconds respectively. In addition, the new car will also offer a 3.0T V6 turbocharged engine version, with a maximum power of 340 Ps and a 0-100 km/h time of 6.0 seconds