Front hood (front hood) introduce

The deformation of the engine hood needs to be repaired through sheet metal. Go to a regular repair shop and the technician will help you handle it. If it is a serious impact deformation, it is recommended to replace it. Even after repairing the surface, the lower reinforcement plate will not be completely repaired, resulting in a significant decrease in the strength of the engine hood, which is not conducive to safe driving; Opening method: There is a cable under the steering wheel, and the handle is pulled open to unlock. Then, both hands lift the engine hood and it will be lifted to a certain height in the middle. Put your fingers in and there is a card that can be pushed in and pushed in to fully open the engine hood. If it is a hydraulic rod, simply pull the handle to open the engine hood)

The installation method of the engine hood in a car needs to be adjusted according to its position

When installing the engine hood on a car, it is necessary to adjust the position. If the installation position of the engine hood is not appropriate, adjustments can be made as follows: ① Unscrew the fixing bolts of the engine hood hinge, move the hinge up and down, left and right to adjust the engine hood. ② Rotate the engine hood buffer block to adjust the height of the engine hood so that it is flush with the front and side edges of the body. ③ After unscrewing the fixing bolts of the engine hood latch, move the latch up and down, left and right to adjust. ④ Close the engine hood and check for alignment with surrounding components, with even gaps

Dongfeng Fengdu MX6 introduce

The Dongfeng Fengdu MX6 is the first SUV of the Zhengzhou Nissan Dongfeng Fengdu brand. It is a professional urban SUV originating from NISSAN, inheriting the rugged lines of an SUV in appearance, and has been upgraded and optimized on the basis of the original configuration. The Dongfeng Fengdu MX6 continues the body of the old Qijun, with a square and sturdy side body that leaves a deep impression. In addition, the MX6 also continues the panoramic sunroof design of the old Qijun, It is expected that there will be many similarities between the interior design and configuration of the car and the old Qijun. According to previous declaration information, the length, width, and height dimensions of the car are 4625/1790/1735mm, and the wheelbase is 2630mm. In terms of power, the MX6 is expected to carry a 2.0L naturally aspirated engine with the code name MR20, with a maximum power of 106kW (144PS) and an optional 6MT and CVT transmission