The following is an introduction to the functions of car front fog lights: 1. Let other vehicles see the car in foggy or rainy weather conditions where visibility is greatly affected by weather. 2. Install in the front of the car slightly lower than the headlights, used to illuminate the road when driving in rainy and foggy weather. 3. It can improve the visibility of the driver and surrounding traffic participants, To enable oncoming vehicles and pedestrians to detect each other from a distance, the following are the operation methods for activating the front and rear fog lights: 1. Joystick on type: Start the fog lights by rotating the switch on the joystick. When the button marked with the fog light signal is turned to the ON position, the front fog lights will turn on, and then turn the button down to the rear fog light position, that is, turn on the front and rear fog lights at the same time. 2. Button on type: Start the front and rear fog lights by pressing the button, and mark the fog light button near the dashboard or center console, Press the front and rear fog light buttons separately to turn on the front and rear fog lights)
1. First, remove the black outer shell of the vehicle fog light, pull out the wiring harness inside, remove the snake head, and leave the plug. 2. Remove the lining near the fog light inside the wheel hub, which can be pried open with a screwdriver or other tools for convenient installation of the fog light later. 3. Install the newly purchased fog light at the wiring harness plug that was just found, fix it with a screwdriver or other tools, and then install it at the dug circular hole, fix it, and finally restore the removed lining
From the perspective of the Mercedes Benz E260L model, the entire series has been equipped with a 2.0-liter low-power version engine and a 48V mild hybrid system, with a maximum engine power of 145 kW and a peak torque of 320 Nm; The previously available E260L is equipped with a 1.5-liter+48V mild hybrid system engine with a maximum power of 135 kW and a peak torque of 280 Nm. From the data, it can be seen that the new E260L equipped with a 2.0-liter engine+48V mild hybrid system performs better in terms of power parameters. Therefore, when driving normally, the new model will not experience the same situation of roaring and not leaving as the old model
Copyright © 2021.Company name All rights reserved.