The clutch three piece set refers to the clutch friction plate, clutch pressure plate, clutch release bearing. The clutch pressure plate is the most important component in the clutch assembly, which directly determines whether the clutch is installed trembling, heavy, and used for a long time. The quality of the clutch friction plate will determine the overall service life and shock absorption and noise reduction effect of the clutch. The clutch release bearing is an important part of the clutch release system, Its quality determines the separation efficiency of the clutch system and the wear rate of the pressure plate separation)
This advocates installation in car repair shops, as the installation method for each car is different: 1. Clutch pressure plate: it is a crucial structure on the clutch, and its function plays a crucial role in driving safety of the car; 2. The clutch is located in the flywheel housing between the engine and transmission. The clutch assembly is screwed onto the rear plane of the flywheel, and the output shaft of the clutch is the input shaft of the transmission. During the driving process of the car, the driver can press or release the clutch pedal as needed, temporarily separating the engine and transmission and gradually engaging them to cut off or transmit power input from the engine to the transmission; 3. The clutch is a common component in mechanical transmission that can be disengaged or engaged in the transmission system at any time. The general requirement is smooth engagement, rapid and thorough separation; Easy to adjust and maintain, with small external dimensions; Small weight, good wear resistance, and sufficient heat dissipation capacity; Convenient and labor-saving, commonly used methods include clamp type and friction type
The Dongfeng Xiaokang K07 II is a van under the Dongfeng brand. It has been adjusted at the front grille, and the layered lines on the side of the body are more prominent. Compared with the old model, the exterior design of the Dongfeng Xiaokang K07 II has been slightly modified. The front grille has been adjusted, and the layered lines on the side of the body are more prominent. In terms of size, its length has increased by 80mm, The height has been reduced by 40mm. This time, we are introducing the lowest configuration model of the entire series - the 1.0L practical model. The front and rear bumpers of the car are black, priced at 29800 yuan. In terms of space, when a 176cm tall tester sits in the car, the front headroom is two fists, and the rear legroom is also two fists. The headroom is more than two fists, and the slight headroom has never been a problem. In terms of the trunk, its minimum depth is 1110mm, Folding the rear seats can expand to 1940mm, but folding them requires the use of tools, which is somewhat inconvenient. Due to the limited size of the body, the performance of the trunk can only be described as average compared to the other three models
Copyright © 2021.Company name All rights reserved.