air conditioning compressor introduce

On the lower right corner of the engine belt, below the generator. The car air conditioning compressor is installed on the engine, and the belt drives the car air conditioning compressor to work together with the engine. You can find the specific location of the car air conditioning compressor by looking for the belt. The following is an introduction to the car air conditioning compressor: 1. The car air conditioning compressor is the heart of the car air conditioning refrigeration system, The compressor plays a role in compressing and transporting refrigerant vapor. There are two types of compressors: constant displacement and variable displacement. According to different working principles, air conditioning compressors can be divided into fixed displacement compressors and variable displacement compressors. 2. In the entire system, the compressor is responsible for compressing and driving the refrigerant. Under the drive of the engine, it continuously sucks in the low-temperature and low-pressure refrigerant vapor generated by the heat absorption and vaporization in the evaporator, which is compressed to form high-temperature and high-pressure refrigerant vapor, Discharged into the condenser, it creates high-pressure conditions for the refrigerant to continuously condense and release heat in the condenser. At the same time, it overcomes the circulating flow resistance of the refrigerant in the refrigeration circuit. Helps the automotive parts platform to provide ordering services for original parts of air conditioning compressors for various vehicle models)

Steps for disassembling and assembling automotive air compressors:

Steps for disassembling and assembling a car air compressor: 1. Disassembly sequence of the compressor: Disconnect the power supply, discharge the refrigerant from the compressor, remove the high-pressure and low-pressure pipes respectively, and seal the nozzles of the high-pressure and low-pressure pipes to prevent foreign objects or air from entering. Disconnect the wires of the electromagnetic clutch. Use a special tool to loosen the fixing bolts of the compressor, remove the triangular belt, and the compressor can be removed. 2. Installation sequence of the compressor: When installing the compressor, It should be noted that the groove surfaces of the clutch pulley and the engine pulley are corresponding and on the same plane. The gap between the condenser and the fan should not be less than 20 millimeters, and the standard gap between the compressor, compressor seat, and hose is 15 millimeters. To prevent refrigerant leakage, please replace the O-ring when installing the high-pressure and low-pressure pipes of the compressor. Tighten all fasteners with the specified tools and torque. Finally, Check for leaks in the engine fuel supply system and cooling system

Dongfeng Xiaokang K07 II introduce

The Dongfeng Xiaokang K07 II is a van under the Dongfeng brand. It has been adjusted at the front grille, and the layered lines on the side of the body are more prominent. Compared with the old model, the exterior design of the Dongfeng Xiaokang K07 II has been slightly modified. The front grille has been adjusted, and the layered lines on the side of the body are more prominent. In terms of size, its length has increased by 80mm, The height has been reduced by 40mm. This time, we are introducing the lowest configuration model of the entire series - the 1.0L practical model. The front and rear bumpers of the car are black, priced at 29800 yuan. In terms of space, when a 176cm tall tester sits in the car, the front headroom is two fists, and the rear legroom is also two fists. The headroom is more than two fists, and the slight headroom has never been a problem. In terms of the trunk, its minimum depth is 1110mm, Folding the rear seats can expand to 1940mm, but folding them requires the use of tools, which is somewhat inconvenient. Due to the limited size of the body, the performance of the trunk can only be described as average compared to the other three models