electron fan introduce

The working principle and function of a car electronic fan are: 1. The working principle is that the car electronic fan is controlled by a temperature controller. When the water temperature rises to the upper limit, the temperature controller connects the power supply, and the fan starts to work. When the water temperature drops to the lower limit, the temperature controller turns off the power supply, and the fan stops working; 2. Its function is to cool the engine block and gearbox, and provide heat dissipation for the air conditioning condenser. The method of replacing the electronic fan is: 1. Open the engine hood of the car and remove the intake pipe located above the fan; 2. Use professional tools to unscrew screws; 3. Unscrew all screws and remove the fan from the car; 4. Install the new fan correctly on the new fan bracket and tighten the four fixing screws; 5. Start the engine to test whether the fan can operate normally. After checking for accuracy, install the intake pipe in the correct position. The Helper Auto Parts Platform provides ordering services for original electronic fan parts for various vehicle models)

The installation method for the electronic fan inside a car is as follows:

The installation method for the electronic fan in the car is as follows: 1. First, remove the intake module from the engine compartment, and then unplug the water tank fan cable hidden behind the intake module; 2. Then lift the car and loosen the fixing screws of the water tank from under the engine to allow the water tank to sink; 3. Remove the radiator fan module from the bottom of the car and replace it with a new fan

Dongfeng Xiaokang K07 II introduce

The Dongfeng Xiaokang K07 II is a van under the Dongfeng brand. It has been adjusted at the front grille, and the layered lines on the side of the body are more prominent. Compared with the old model, the exterior design of the Dongfeng Xiaokang K07 II has been slightly modified. The front grille has been adjusted, and the layered lines on the side of the body are more prominent. In terms of size, its length has increased by 80mm, The height has been reduced by 40mm. This time, we are introducing the lowest configuration model of the entire series - the 1.0L practical model. The front and rear bumpers of the car are black, priced at 29800 yuan. In terms of space, when a 176cm tall tester sits in the car, the front headroom is two fists, and the rear legroom is also two fists. The headroom is more than two fists, and the slight headroom has never been a problem. In terms of the trunk, its minimum depth is 1110mm, Folding the rear seats can expand to 1940mm, but folding them requires the use of tools, which is somewhat inconvenient. Due to the limited size of the body, the performance of the trunk can only be described as average compared to the other three models