Differential assembly of transfer case introduce

The so-called transfer case of a car can be understood literally: its main purpose is to distribute the power of the engine and output it to the front and rear axles. Therefore, the transfer case is actually a standard accessory in four-wheel drive models. According to the different forms of four-wheel drive, there are generally several types of transfer cases: traditional part-time four-wheel drive transfer case, full-time four-wheel drive transfer case, timely four-wheel drive transfer case, and optional four-wheel drive transfer case)

Installation method for differential assembly of transfer case

1. First, clean all components. 2. Assemble the differential, install the driven hyperbolic gear, install the driven gear bearing cover, and adjust the preload of the driven gear bearing. 3. Install the driving hyperbolic gear and oil seal seat on the bevel gear bearing seat and adjust the preload of the driving gear bearing through the gasket. 4. Install the driving hyperbolic gear and adjust the meshing clearance and imprint of the main and driven bevel gears by adjusting the gasket between the driving bevel gear bearing seat and the main reducer housing and rotating the nuts on both sides of the driven bevel gear

Dongfeng Xiaokang K07 II introduce

The Dongfeng Xiaokang K07 II is a van under the Dongfeng brand. It has been adjusted at the front grille, and the layered lines on the side of the body are more prominent. Compared with the old model, the exterior design of the Dongfeng Xiaokang K07 II has been slightly modified. The front grille has been adjusted, and the layered lines on the side of the body are more prominent. In terms of size, its length has increased by 80mm, The height has been reduced by 40mm. This time, we are introducing the lowest configuration model of the entire series - the 1.0L practical model. The front and rear bumpers of the car are black, priced at 29800 yuan. In terms of space, when a 176cm tall tester sits in the car, the front headroom is two fists, and the rear legroom is also two fists. The headroom is more than two fists, and the slight headroom has never been a problem. In terms of the trunk, its minimum depth is 1110mm, Folding the rear seats can expand to 1940mm, but folding them requires the use of tools, which is somewhat inconvenient. Due to the limited size of the body, the performance of the trunk can only be described as average compared to the other three models